 |
With
both rails installed at the right height, I can insert the hardware that will be the start
of the base section.
|
The next step is to remove the protective paper from the glide pads and place them in position on the base clamps. |
 |
 |
I have attached the base clamps to the ends of the base support panel. |
With the base support assembly in place on the rails, I am ready to add the Incra Jig Ultra. |
 |
 |
I use a measuring tape to center the Ultra. |
I use a square to keep it in alignment as I tighten the screws. |
 |
 |
I can now install the Incra Ultra carriage into the guide. |
I slide the fence into position. |
 |