Project — "Solid Mahogany Vanity Top" Page 3

She can use this scale to set the vertical placement of the mortise.
	Marieanne's has installed the Cross Stop attachments on the joiner and is setting both to 100 mm.
She attaches the power cord and the dust extraction hose. She is almost ready to use the joiner.
	She marks the ends of the boards so that she will know where to reference when she starts making mortises.
Since she will be locating mortises using Domino's auto positioning, she makes sure she always starts with the edge marked with her "X".
	She uses the Domino Joiners internal stops for positioning for the first mortise.
For subsequent mortises, she uses the Cross Stop pin stopped in the previous mortise to position the next mortise.
	When that side is done, she turns the board around and since the X is at the right, she starts her mortises from the right edge.
This time she uses the opposite Cross Stop arm and moves the joiner from right to left.
	And this is the perfect picture. All the mortises perfectly lined up with close spacing to the edge and then nicely spaced from that point on.
She applies glue over the edges and the tenons.
	She tightens two clamps on what will be her very first panel glue-up. And you can't get a finer assembly than this. Marianne and Domino Joiner are a winning pair.